Seagate ST39103LC Guida Utente Scaricare il pdf (Pagina 41)

Chapter 4. SVA Path Installation 31

Chapter 4. SVA Path Installation

This chapter describes how to install SVA Path for use with SVA

9500.

Installation of SVA Path in HP-UX is managed by the SD-UX

software management commands. Many of these tools (e.g.,

swinstall and swremove) can be run either from the command

line or from a Graphical User Interface (GUI). The following

instructions illustrate using the command line. However, the same

tasks can be accomplished through the GUI. For more information

on this alternative consult your HP-UX documentation for

swinstall and swremove.

Note: If your system contains current logical volumes, please

read the section titled "Reconfiguration for Existing Logical

Volumes" beginning on page 46 before installing SVA Path.

Installing SVA Path on HP-UX

Follow these steps to install the SVA Path driver and its supporting

files.

1. Domain addresses must be automatically configured to be

set to zero (refer to “SVA Path Hardware Setup”, beginning

on page 5).

2. Log in as

root on the host on which you are installing SVA

Path.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Nessun commento

Seagate ST39103LC Guida Utente Pagina 41